|
|
Post by bigbubbalj on Mar 10, 2006 0:10:28 GMT -5
lifted my LJ with Rusty's 2" coil kit......my rear axle has now shifted to the passenger side by 3/4"....too much? will it mess up anything being that far off?
I don't like the way it looks and would like to fix it. I got a OME relocation kit. what is involved in putting this on? I know I have to drill new holes.....what else? How hard is it to do? thanks as usual for the help guys.
|
|
|
|
Post by moneypit on Mar 10, 2006 20:20:02 GMT -5
The bracket is not hard to install. It will move the axle back where it was. You will need a right angle drill and I think a 7/16th drill bit. Check that before drilling. It is just hard to get into the area the bracket goes to get the nuts started. If you have someone with small hands around to help at that point it will make it easier. If you ever want to go higher then 2- 2 1/2" skip the bracket and buy an adjustable trackbar. If you need a write up let me know and I will find the one I used on the OME.
|
|
|
|
Post by Belfast on Mar 10, 2006 20:41:25 GMT -5
Is this normal? I put on a 2" BB and didn't notice any shift once everything was back together.
|
|
|
|
Post by RubiRedLJ on Mar 10, 2006 22:10:31 GMT -5
Is this normal? I put on a 2" BB and didn't notice any shift once everything was back together. I now when I put on my RE 2" BB, my a$$ end was shifted a little to the passenger side. Maybe 3/4" at the most. I'm not going to worry about it until I lift it more... ryan |
|
|
|
Post by bigbubbalj on Mar 11, 2006 1:40:36 GMT -5
yeah 3/4" is how much mine moved....I will tackle this on Sunday and let you all know....thanks for the input!!
|
|
