metal
Member
I get a title?
Posts: 18
|
Post by metal on Oct 9, 2005 9:21:12 GMT -5
What is everyone paying for a rear CV driveshaft and where did you purchase it?
|
|
|
|
Post by larryb on Oct 11, 2005 1:46:55 GMT -5
I purchased mine from High Angle Driveline but dont recall exactly what i paid for it. Also if you remove the stock vibration dampener be sure the speedo ring is fully seated with the index pin on the main shaft before reinstalling the vibration dampener or you willl have vibrations and headache to clean up and repair . There is a big thread over at ROF that i was a victim of with my curent rubi but had no problems with my last short wheel based rubi. www.rubiconownersforum.com/phpbb2/viewtopic.php?t=23258&highlight= |
|
metal
Member
I get a title?
Posts: 18
|
Post by metal on Oct 12, 2005 21:54:12 GMT -5
Thanks for the onfo larryb but my Unlimited is not a Rubicon therefore, no vibration dampner. I have the dreaded slip yoke on the transfer case. I am installing a SYE so I need a new driveline.
I called Tom Woods and they were about $260 to $300 shipped depending on how strong you want it.
|
|
