|
|
Post by timmy24540 on Dec 15, 2007 15:48:30 GMT -5
Finally got the ACOS and installed them last night and finished today. Took it out for a short ride and the banging was gone  . Almost every time I hit a bump it would bang/clunk, the front was at 6" from the tire and the rear was at 7 3/4", the winch, plate and bumper really add up. I'll leave the it as is. Going to put the hard top on today, this will probably even it out. |
|
|
|
Post by skipperb on Dec 16, 2007 0:17:53 GMT -5
I have a 2" BB and it sits down in the front. the shop said I could do it or use 3" springs in the front. its about the same price . Do you still have room to adjust if you need to. my winch and bumper are the problem also.Is it just swapping the 2" puck out and putting in the ACOS.
|
|
|
|
Post by timmy24540 on Dec 16, 2007 10:09:44 GMT -5
Yeah, I had a 3/4" spacer and it had dropped quite a bit. It's easy, just take out the puck and the stock rubber bushing and put in the ACOS. Adjust if you need to. You'll might need to adjust it after installation, I had about 3/4" after. I left it alone cause I put the hard top on right after. It should balance out(?).
|
|
|
|
Post by RubiRedLJ on Dec 16, 2007 12:03:34 GMT -5
I left it alone cause I put the hard top on right after. It should balance out(?). I know when I put my hardtop on this fall, (first winter with my RE lift), the hardtop almost leveled out the Jeep. I have a Kilby front bumper, BUT NO winch yet. In the rear, a Jeeperman rear tire carrier & full size spare. I did install a 3/4" spacer when I did my lift, in preparation of the rake I would encounter up front. Now with the hardtop, it's just about level.  |
|
